HBP TWO-CIRCUIT – BATTERY

hydronic – programmable

This HBP Series was intended to be used as a 2 circuit thermostat controlling a circulation pump and a fan on a hydronic coil heating system, though it could have other uses where you need a 2 circuit control with a 1 minute delay on the 2nd circuit. This control will solve the historic problem of using a standard 22 Amp bi-metal heating thermostat on a hydronic system which require high Amp loads to be accurate. Without a load on a Bi-metal thermostat it will not shut off circulating hot water when not needed. This HBP control positively controls both circuits creating energy savings, superior control and comfortable living spaces.

  • 2 Circuit Control of Pump & Fan for Hydronic System
  • 5+1+1 Day Programmable
  • Accuracy: ± 0.9°F
  • AA battery powered
  • 120 / 208 / 240volt / 16amp
  • Range: 40°F to 95°F (4°C – 35°C)
  • Save up to 28% on your heating costs
  • Electronic temperature sensing is the most accurate technology
  • 3 minute cycle rate reduces temperature swings and increases comfort at all control settings
  • LCD backlight display with temperature
  • LCD heater ON indicator
  • Dual single pole design with three wires
  • Imported to King Specifications
  • 1-year limited warranty

Available Models

Ordering Information

MODELUPCTYPEPACKAGINGWIRE LEADSVOLTSAMPS PER POLETEMP. RANGE
HBP190515+1+1 Day Electronic ProgrammableBox (50 pieces)3 Wire120/208/2401640°F-95°F

Engineering Specs

Temperature Range: 40°F to 95°F (4°C – 35°C)

Temperature Default: 68°F (20°C)

Display Format: LCD

Display Size: Large Format

Sample Rate: Every 60 seconds

Delay On or Off: 3 minutes

Heat Indicator: LCD “heater on”

Relay Rating: 16 Amps

Relay: AA battery powered

Accuracy: ± .9°F @ 2000W

Maximum Amps: 16 resistive

Maximum Watts: 3840 @ 240V – 3328 @ 208V – 1920 @ 120V

Minimum Watts: 0

Power Supply: 1-240VAC / 1-30VDC

  • 16 Amps at 240V, 3840 Watts.
  • 16 Amps at 208V, 3328 Watts.
  • 16 Amps at 120V, 1920 Watts.
  • Three wire installation.
  • Snap action relay built-in.
  • Wire leads #12 AWG.
  • No depth into wire box.
  • 40°F to 95°F (4°C to 35°C) set point range.
  • Dual switch operation.
  • Electronically anticipated.
  • Battery operated by AA batteries
  • Thermistor sensor.
  • Contemporary styling.
  • Digital thermometer/set point.
  • LCD display.
  • Meets all energy requirements.
  • 1.5 degrees maximum.
  • 3 min. delay between cycles.