HWP120 TWO-CIRCUIT

hydronic – programmable

The HWP (hot water) Series Programmable thermostat was intended for use as a 2 circuit thermostat controlling a circuit pump and fan on a hydronic coil heating system, though it could be used when needing a 2 circuit control with 1 minute delay on the second circuit. This control solves the historic problem of using a standard 22 Amp bi-metal heating thermostat on a hydronic system which require high Amp loads to be accurate. Without a load they will not shut off properly, continuing to circulate hot water when not needed. This control positively controls both circuits creating energy savings and superior comfort control, while providing excellent hydronic control.

The HWP adds 7 independent day programming with 4 times and temperature settings per day to save energy and also start system before you get home.

  • 7 Independent Day Programming with 4 Times & Temperature Settings Per Day
  • Accuracy: ± 1.2°F @ 10 Amps, ± .9°F @ 4.2 Amps
  • 12.5 Amps / 120 Volts
  • Range: 44°F to 95°F (7°C to 35°C)
  • Save Up to 28% On Your Heating Costs
  • Electronic Temperature Sensing is The Most Accurate Technology
  • 3 Minute Cycle Rate Reduces Temperature Swings & Increases Comfort at All Control Settings
  • 2 Circuits, 1 Minute Delay on 2nd Circuit
  • LCD backlight Display with Temperature
  • Imported to King Specifications
  • 1-Year Limited Warranty

Available Models

Ordering Information

MODELUPCTYPEWIRE LEADSVOLTSAMPSTEMP. RANGEPURCHASE
HW12019048Electronic Line Voltage4 Wire12012.540ºF-95ºFBuy Now
HWP120190477 Day Independent Electronic Programmable4 Wire12012.544ºF-95ºFBuy Now
HWPT120190497 Day Ind. Elec. Prog. w/ 15 min. pump timer every 24 hrs.4 Wire12012.544ºF-95ºFBuy Now

Engineering Specs

Temperature Range: 44°F to 95°F (7°C – 35°C)

Temperature Default: Your saved setting

Display Format: LCD

Display Size: Large Format

Sample Rate: Every 60 seconds

Delay On or Off: 3 minutes

Heat Indicator: LCD “heater on”

Relay Rating: 12.5 Amps

Accuracy: ± .9°F @ 2000W

Maximum Amps: 12.5 resistive

Maximum Watts: 3000 @ 240V 2600 @ 208V – 1500 @ 120V

Minimum Watts: 0

Power Source: 120VAC, 50-60Hz

  • 12.5 Amps per circuit.
  • Four wire installation.
  • Snap action relays.
  • Wire leads #16 AWG.
  • 3⁄4″ depth into wire box.
  • 44°F to 95°F (7°C – 35°C) set point range.
  • Thermistor sensor.
  • Digital thermometer/set point.
  • Large LCD display.
  • Meets energy code requirements.
  • 1.2 degrees differential.
  • 3 min. delay between cycles.
  • 1 min. delay between circuits.
  • For use on hydronic fan coils.
  • On/Off switch for green backlight & system.
  • Battery backup.
  • HWPT adds exerciser pump timer.